How to recycle Waste Aluminum fin tube efficiently

If you work with air conditioners, refrigeration units, or heat exchangers, you know the hassle of recycling steel-aluminum composite finned tubes. These tubes—with aluminum fins wrapped around steel pipes—are everywhere, but recycling them used to be a nightmare. Either you spend too much money on manual work or harsh chemicals, or you end up damaging the steel pipes and wasting valuable resources. But here’s the good news: there’s a machine that fixes both problems, and this Waste Aluminum fin tube stripper Machine is designed specifically for recycling steel tubes with diameters between 16mm and 32mm.

Meet the steel-aluminum composite finned tube peeling machine (also widely known as a Waste Aluminum fin tube stripper Machine). Its main job is simple: peel off the aluminum fins from the outer wall of the steel tubes—quickly, efficiently, and without scratching or bending the inner steel pipe. For anyone tired of high recycling costs, this Waste Aluminum fin tube stripper Machine is a game-changer. Let’s break down why it works so well for 16-32mm tubes, plus how to operate it step by step.

First, it solves the “cost trap” of traditional recycling. Manual peeling is slow—one worker might take hours to process a few tubes—and it’s easy to damage the steel pipe by mistake. Chemical stripping or burning? Those methods are expensive, bad for the environment, and often ruin the steel entirely. This peeling machine, though, handles the job automatically. As a professional Waste Aluminum fin tube stripper Machine, it fits perfectly with steel tubes from 16mm to 32mm (the most common sizes in ACs and heat exchangers) and peels off aluminum fins in seconds. No more wasting time or money on inefficient methods.

Second, it stops resource waste. The best part of this Waste Aluminum fin tube stripper Machine is that it keeps the steel pipe intact. After peeling, the steel tube is clean and undamaged—so you can reuse it for repairs, resell it, or recycle it for higher value. The aluminum fins, once separated, can also be recycled separately. That means you’re not throwing away usable steel or aluminum anymore—you’re turning waste into profit. For small workshops or big recycling plants, this translates to more money saved and more resources put back into use.

How to Operate the Machine

Using this user-friendly Waste Aluminum fin tube stripper Machine is straightforward. Just follow these 4 simple steps:

1. Connect the power supply and verify whether the current and switch are normal.

2. Adjust the distance between the two knives to match the diameter of the inner tube of the aluminum finned tube. The distance between the two knives can be adjusted at will—turn the front and back nuts on both sides to bring the knives to the correct distance (ensure the gap between each knife and the tube is consistent), then fix them with hex screws. Double-check the distance and re-fix if needed.

3. Locate the backer, clamp the aluminum finned tube firmly, and then tighten the fixing screws.

4. Turn on the switch and start the operation—let the machine do the hard work for you!

If high costs and wasted resources have been holding back your recycling work, this steel-aluminum composite finned tube peeling machine (Waste Aluminum fin tube stripper Machine) is the solution. It’s built for the most common tube sizes (16mm-32mm), peels efficiently, protects the steel pipe, and boosts your resource recovery rate. Say goodbye to expensive, wasteful methods—this machine turns recycling into a smart, profitable task!